Unit 1 spent fuel pool cooling under control

15 August 2011

TEPCO has started an alternative two-loop cooling system at the Fukushima Daiichi unit 1 spent fuel pool, 10 days after starting a similar system in unit 4. With this system, it has been able to determine the spent fuel water temperature for the first time since the incident (debris had blocked a thermometer dangled from the concrete pump). Two days after the cooling system was switched on, the pool’s water temperature was measured to be 39.5°C. All four units’ spent fuel pools are now cooled by an active circulating cooling system.

In other news, TEPCO workers sampled gas inside the unit 2 primary containment vessel. The nuclides found in greatest quantities were relatively long half-life fission products such as Kr-85, (half-life 10.76 years) and Xe-131m, (12 days), suggesting that the core had not gone critical again recently. Other short half-life nuclides such as Xe-133 (5 days), Xe-135 (9 hours) and Xe-138 (14 mins) should have been detected, but were not. Levels of Cs-134 and Cs-137 were 20-100 times lower than those detected in air sampling of unit 1, depending on the exact sample.

Also, the Fukushima Daiichi water treatment system was augmented with five evaporative desalination systems (three from Areva and two from Toshiba), with a total combined capacity of 250 m3/day. The fresh water produced is injected back into the reactors, and the most concentrated salt water is stored in a concentrated liquid storage tank. Another 750m3/day of desalination capacity is expected to start up in October.




Privacy Policy
We have updated our privacy policy. In the latest update it explains what cookies are and how we use them on our site. To learn more about cookies and their benefits, please view our privacy policy. Please be aware that parts of this site will not function correctly if you disable cookies. By continuing to use this site, you consent to our use of cookies in accordance with our privacy policy unless you have disabled them.